vak: (Daemon)
[personal profile] vak
Перетащил драйверы SPI, UART и SD card из RetroBSD. Ядро весело пытается монтировать файловую систему. А фигушки: не готова еще.
Load file: '/local/BSD/pic32sim/demo/wifire/boot.hex', 6916 bytes
Load file: '/local/BSD/Tilden/sys/compile/WIFIRE.pic32/vmunix.hex', 472904 bytes

***** Start 'microAptivP' *****
Copyright (c) 1982, 1986, 1989, 1991, 1993
	The Regents of the University of California.  All rights reserved.

4.4BSD-Lite build 8 compiled 2014-07-11
    vak@kucha:Tilden/sys/compile/WIFIRE.pic32
cpu: PIC32MZ2048ECG100 rev A4, 200 MHz
oscillator: system PLL div 1:6 mult x50
real mem = 512 kbytes
avail mem = 336 kbytes
using 16 buffers containing 49152 bytes of memory
spi1 at pins sdi=F1/sdo=C1/sck=D1
spi2 at pins sdi=F0/sdo=D11/sck=G6
spi3 at pins sdi=B10/sdo=C4/sck=B14
spi4 at pins sdi=F5/sdo=G0/sck=D10
uart1 at pins rx=D14/tx=D15, interrupts 112/113/114
uart4 at pins rx=F2/tx=F8, interrupts 170/171/172, console
sd0 at port spi3, pin cs=C3
bpf: lo0 attached
sd0: type I, size 206848 kbytes, speed 12 Mbit/sec
rd0a: type b7, start 2, length 204800
rd0b: type b8, start 204802, length 4096
rd0c: type b7, start 208898, length 204800
ufs_mountroot failed: 5
panic: cannot mount root
syncing disks... done

dumping to dev 1, offset 205824
dump device bad
***** Stop *****
This account has disabled anonymous posting.
If you don't have an account you can create one now.
HTML doesn't work in the subject.
More info about formatting

If you are unable to use this captcha for any reason, please contact us by email at support@dreamwidth.org